EPROM+ PROGRAMMING SYSTEM SOFTWARE

The EPROM+ software provides the foundation for a powerful yet easy-to-use programming system. The software is compatible with nearly any PC with an X86 processor. The distribution disk includes its own operating system and is bootable on any host machine allowing it to work with or without Windows. Although fully compatible with all versions of Windows (including VISTA and Win7), you never need to be concerned with installing software or drivers to use the system. The program has a simple, elegant user interface and can easily be installed on your hard drive. A primary feature of the EPROM+ is that you can use it with any available computer, no matter what the age, operating system or configuration. You simply connect the programming unit to the host machine, connect the power pack, insert the program media, start the program or reboot the machine (boots in less than 20 seconds). There is no software installation necessary unless you specifically choose to do so. When the program starts it will automatically locate the programming unit. When you end your work, shut down the program and disconnect the programming unit. The system leaves no residual files on the host computer. It does not write to the Windows registry or in anyway become entangled with the host operating system. This is true for all versions of Windows and is a unique feature of the EPROM+ system.

Windows 7

VISTA

Windows XP

Windows 2000

Windows ME

Windows 98

Windows 95

Windows 3.1

DOS

Commands are selected and executed directly from a single window. Following a command choice, the command description is hi-lited. Any information the system requires from you is entered in the bottom left. While the system is performing an operation, the progress and status are reflected in the lower right. There are no confusing multi-level menus in which to get lost or through which to search looking for a feature. All commands, options and the system status are always visible. Each system command is listed below. Click on a command name for a detailed description.

 

SYSTEM COMMANDS
  EXIT PROGRAM/SYSTEM OPTIONS   SAVE BUFFER TO DISK FILE
  PROGRAM DEVICE FROM DISK FILE   SAVE DEVICE TO DISK FILE
  PROGRAM DEVICE FROM BUFFER   DIRECTORY OF FILES
  READ DEVICE INTO BUFFER   DISPLAY/SELECT PROG. ALGORITHM
  READ DISK FILE INTO BUFFER   DEVICE/FILE CHECKSUM
  BUFFER EDITOR   SET DRIVE/PATH
  VERIFY DEVICE IS ERASED   REMOVE/DELETE FILE
  COPY DEVICE   DIP SWITCH SETTINGS
  COMPARE DEVICE WITH BUFFER   MANUALLY SET PROG. VOLTAGE
  CHANGE DEVICE TYPE   DEVICE OPTIONS

BACK TO HOME PAGE